LYNX - TC3 SERIES COMMERCIAL OPERATORS

• 1/2 HP, 3/4 HP, and 1 HP - 115V/230V-1 Phase Motor
  • 208/230/460/575V-3 Phase Motor
• 3 Button station (NEMA 1)
• 1650 RPM, high starting torque motor with overload protection
• LX 100 BOARD Standard Features
  • B2 Mode, C2 Mode, D1 Mode, E2 Mode, T Mode, TS Mode
    
• On board, Open, Close, & Stop for ease of setting limits
• Photo-eyes included
• Pre-wired to accept sensing devices
• 24 Volt accessory power
• On board (372 MHz) receiver capable of programming up to 20 transmitters
• External receiver connection
• Ground level disconnect for manual operation
• NEMA 1 Electrical enclosure
• Adjustable friction clutch
• Primary Drive: Heavy Duty 4L V-Belt - #65 Drive Chain
• Door speed:  Approx. 10” per second
• Doors up to 18 feet high
  

LYNX - CONTINUOUS DUTY JACK SHAFT OPERATOR

• 1/2 HP, 3/4 HP, and 1 HP - 115V/230V-1 Phase Motor
  • 208/230/460/575V-3 Phase Motor
• 3 Button station (NEMA 1)
• 1650 RPM, high starting torque motor with overload protection
• Inherent Mechanical Brake (I.M.B)
• LX 100 BOARD Standard Features
  • B2 Mode, C2 Mode, D1 Mode, E2 Mode, T Mode, TS Mode
• On board, Open, Close, & Stop for ease of setting limits
• Photo-eyes included
• Pre-wired to accept sensing devices
• Ground level disconnect for manual operation
• 24 Volt accessory power
• On board (372 MHz) receiver capable of programming up to 20 transmitters
• External receiver connection
• NEMA 1 Electrical enclosure
• Adjustable friction clutch
• Maximum Output Revolutions - 45
• Primary Drive: Heavy Duty 4L V-Belt
• Secondary: #41 CHAIN / SPROCKETS
• Output: #50 CHAIN / SPROCKETS
• 32 RPM output shaft speed
• Door speed determined by the door system installed
• Standard sprockets:
  • Sectional:  50B12 x 1” bore to 50B18 x 1” bore OR 50B18 x 1 1/4” bore
  • Steel Rolling:  50B12 x 1” bore to 50B24 x 1 1/4” bore